Train
How to time your footwork with Shuttle Knockdown
Lay shuttles out on court, knock them down and tap your phone: every set is timed, so you see how fast you move, whether you fade, and how it compares with last time.
Updated
Shuttle Knockdown times your footwork. You stand shuttles up at spots on court, knock one down at each spot in a set, and tap the phone to end the set. Every set is timed. The footwork simulator and interval timer set your pace for you; Shuttle Knockdown measures how fast you go.
Before you startLink to this section
- You need Plus, Pro or Coach. Shuttle Knockdown is in the GGAB app only: under Training → Tools on Pro and Coach, and on your home screen on Plus.
- Shuttles: enough to stand the same number at every spot. In Four corners the phone takes one corner, so 5 at each of the other three takes 15.
- Somewhere to put the phone on the floor, screen up, where you can tap it on the way past.
Build the courtLink to this section
Pick a patternLink to this section
Open Shuttle Knockdown. Choose one of your patterns, a starter pattern to copy, or New pattern for an empty court.
The starters are Four corners, Six corners, Base + corners, Front–back and Side to side.
Place the phone and the spotsLink to this section
Put the phone on the map where it will sit on court, and a spot wherever you'll stand shuttles up.
- Tap the court to add a spot. Tap a spot to remove it.
- Drag the phone or a spot to move it.
- The phone takes a spot's place. Drop it on a spot and tapping it stands in for knocking that one down. In Four corners the phone is the front-left corner: tap, knock down the other three clockwise, tap again.
- Snap to spots puts spots and the phone on the named positions. The corners are where the singles sidelines meet the short service line and the doubles long service line, the mids sit halfway between, and Base is the middle. Turn it off to place either anywhere, the phone off court included.
- Spots are numbered in the order you add them, and that's the order you run them. Reorder renumbers them: tap the spots in the new order.
The phone stands in one spot: tap it there instead of knocking a shuttle down. The other spots are numbered in the order you run them.
15 shuttles · 5 sets of 3
Set the runLink to this section
| Setting | What it does |
|---|---|
| Order | Pattern runs the spots in their numbered order. Random means you choose: one shuttle from every spot each set, in any order. The app never tells you where to go. |
| Shuttles at each spot | How many shuttles stand at every spot. |
| Shuttles per tap | In Pattern, how many you knock down before tapping the phone. It can be fewer than the spots: with 4 spots and 2 per tap, sets alternate 1–2 then 3–4. |
| Start | From the middle goes from Go straight to the set's spots. Phone first makes the phone the first point you move to: from the middle, tap the phone, then knock down the set. That tap doesn't end the set; the next one does. |
| Rest between sets | Off runs straight on from each tap. With rest on, each rest ends with another 3, 2, 1, Go. |
| Get ready | Seconds to walk to the middle after Start. |
| Log to training | Adds the run to today's training. |
The line above Start shows what that adds up to, such as "15 shuttles · 5 sets of 3". If the shuttles don't divide evenly, it tells you how many the last set has.
Run itLink to this section
Start in the middleLink to this section
Put the phone down, press Start and walk to the middle of the court. Three beeps count you in, 3, 2, 1, and a higher beep is Go. You don't need to watch the screen.
Knock down, then tapLink to this section
From Go, knock down a shuttle at each spot in the set, come back to the phone and tap anywhere on the screen. The tap ends that set and starts the next one straight away.
In Pattern order the screen lights the spots for the set you're on. In Random it shows no order.
With Phone first on, a set that starts from the middle begins at the phone: the screen says Phone first until you tap it, then the set carries on to its spots. Its time still runs from Go to the tap that ends it.
A second tap within one second is ignored, so a double tap or a stumble doesn't end a set early. Undo last tap puts a set back together if you tapped by mistake.
Pause or end earlyLink to this section
Pause stops the clock. The set you were in isn't counted, because a time with a break in it isn't a time. Stand its shuttles back up, press Resume, walk to the middle, and that set starts again on its own 3, 2, 1, Go.
End finishes the run and keeps every set you completed.
Read your resultsLink to this section
Shuttle Knockdown · Four corners
9.5
seconds per set, average
Vs last run
−0.1 s
Faster
Vs your best
+0.3 s
Best 9.2 s, Oct 22
Total
0:47.5
Best set
8.9 s
Set 2
Slowest set
10.4 s
Set 1
Fade
+10.1%
Slower by the end
Distance
~89 m
Straight lines
Speed
1.9 m/s
Estimated
Seconds per set
9.5 sAverage per set. Point at a set to read it.
- Seconds per set, average is the headline: lower is faster.
- Vs last run and Vs your best compare with your earlier runs of the same layout (see below).
- Best set and Slowest set are your quickest and slowest single sets.
- Fade compares the last third of your sets with the first third. A plus means you slowed down by the end.
- Distance and Speed add up the straight lines between your spots, so they're estimates, and they only show in Pattern order. A random route is yours, so the app can't know it.
- Seconds per set charts every set against your average. Point at a set (or tap it in the app) to read it.
Set 1 starts from the middle, but without rest every later set starts at the phone, so set 1 isn't a like-for-like start. It's outlined on the chart, marked From the middle, and left out of fade. The same goes for a set restarted after a pause. With rest on, every set starts from the middle, so they all count.
Save and compareLink to this section
On a new or starter layout, press Save and give it a name. After that the pattern saves itself as you change it: the header says Saved. Tap the name to rename it. In the patterns list, the ••• menu on a pattern renames, duplicates or deletes it.
A run compares only with runs of the same layout: the same spots, phone, order and shuttles per tap. Changing the shuttles at each spot, the rest or the get-ready time keeps the comparison, so a 5-set and a 6-set run still compare on average per set.
Moving a spot or the phone, or changing the order, shuttles per tap or Start, starts a fresh comparison. Your earlier runs aren't lost: they stay in Training, and the pattern's Runs of this layout card says how many were on the old layout.
Deleting a pattern keeps its runs in Training.
See your progressLink to this section
History (top of the patterns list, or History on a pattern's Runs of this layout card) shows every run you've logged. Filter by Pattern and by Dates: the last 30 days, 3 months, 12 months, all time, or your own range.
- All patterns lists each pattern you ran in those dates, with your latest average, your best and how much it moved.
- One pattern shows your runs, your best, and the change from your first run in the range to your latest, with a chart of seconds per set over time. Lower is faster, so a falling line is progress. Tap a run on the chart to read it, or a run in the list to open its training session.
The chart only follows the pattern's current layout. Runs on an earlier layout are listed and marked earlier layout, but they aren't on the line, because they weren't the same drill.
From your coachLink to this section
A coach can send you a Shuttle Knockdown pattern as part of a session. Your phone gets a notification; open the session and tap Start on the pattern to run it, with the coach's spots, phone, shuttles and rest already set. The run logs to that session, not today's, and marks it completed, so your coach sees it.
For coaches: in Assigned training → Assign, add a pattern under Shuttle Knockdown. Pick a starter or one of the patterns you saved in the app, then set this assignment's shuttles at each spot, rest, order and start. Each pattern goes as its own drill, and repeating sessions carry it to every date.
Where your runs goLink to this section
With Log to training on, each run is added to today's training session as a Drill, under the pattern's name, such as "Shuttle Knockdown: Four corners". If you have no session today, it starts one. Average seconds per set is tracked over time under Training → Tests, next to your beep test, and GGAB reads it when you ask about your speed.
TroubleshootingLink to this section
- A tap didn't end the set. It came within a second of the last tap or of Go, and was taken as a double tap. Tap again.
- No sound. Turn the volume up. The beeps play with the phone on silent.
- My run says it's the first of this layout. Something in the layout changed since your last run: a spot or the phone moved, or the order or shuttles per tap changed.
- I can't open Shuttle Knockdown. It's part of Plus, Pro and Coach. See Account, billing and privacy for the plans.
Related guidesLink to this section
This page answers
- How do I time my footwork?
- How does Shuttle Knockdown work?
- Where do I put the phone for Shuttle Knockdown?
- What does random mean in Shuttle Knockdown?
- What is fade in Shuttle Knockdown?
- Why is set 1 slower in Shuttle Knockdown?
- Can I pause Shuttle Knockdown?
- How do I save a Shuttle Knockdown pattern?
- Why doesn't my run compare with my old runs?
- Is Shuttle Knockdown on Starter?
Was this page helpful?